This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Faculty of Technical Sciences, University of Priština - Kosovska Mitrovica , Mitrovica , Kosovo
Faculty of Technical Sciences, University of Priština - Kosovska Mitrovica , Mitrovica , Kosovo
Faculty of Technical Sciences, University of Priština - Kosovska Mitrovica , Mitrovica , Kosovo
Faculty of Technical Sciences, University of Priština - Kosovska Mitrovica , Mitrovica , Kosovo
This paper presents the Taguchi method and regression analysis for obtaining surface roughness in end milling of aluminum 6082-T6. Surface roughness was measured using a Mahr profilometer. The values of the experimental measurements were compared with the values obtained by regression analysis. The optimization was performed using the Taguchi method, which showed the greatest influence of the cutting parameters (cutting speed, feed rate, depth of cut) on surface roughness.
The statements, opinions and data contained in the journal are solely those of the individual authors and contributors and not of the publisher and the editor(s). We stay neutral with regard to jurisdictional claims in published maps and institutional affiliations.
